TT
GOLD MEMBER
387 posts
Mar 06, 2009
5:43 PM
|
I was kinda bored today and decided to make my first prototype feeder for my nest fronts, The only reason i went this route is due to all the mess these birds make with the waste of feed, So i called up a friend of mine that owns a glass shop and asked if he had some 1/4 Plexiglas laying around, he gave me a sheet 2x4x1/4, I thought that would be a good size to play around with, so i came up with this clean design.
P.s my nest fronts have a removable front door where i replaced it with the feeder.
Enjoy!
----------
Tony...
Last Edited by on Mar 06, 2009 5:44 PM
|
TT
GOLD MEMBER
388 posts
Mar 06, 2009
5:45 PM
|
One other note, I need to MASS produce 19 more lol.
----------
Tony...
|
Joe Dan
144 posts
Mar 06, 2009
7:58 PM
|
Jedds also sells feeders very similar to these... except thay come in either 1 hole or 2 hole, and they have a hinged lid on the top that is actually on a 45 degree angle. They are a bit spendy though... I have them on my 18 singlemate pens... I like them... I too got tired of the mess... and more importantly... the waste...
----------
Joe Dan Parson
Full Turn Lofts
North Texas
|
tthoj
50 posts
Mar 07, 2009
9:38 AM
|
This is nice might steal this idea.
Thomas Thao
|
Pararoller
43 posts
Mar 07, 2009
10:22 AM
|
thats what i was asking from tony thats what i need the breeder makes too much mess with regular feed tray let me know on this products if avaible
|
kopetsa
59 posts
Mar 07, 2009
10:33 AM
|
nice
|
harrison
332 posts
Mar 07, 2009
11:43 AM
|
good idea mate.
I have a breeders open section and also a few cages for breeding. And they have wire floors and you can be sure that 60% of the dailey feed ends up underneath the wire floor wasted coverd in sh*T.
I may use wood to make them (THIN BOARD) as it would be easyer to use.
Thanx again. yours in roll harrison uk hull.
|
